How to Modify Skytap WAN/VPN Remote Subnets

Administrators in your Skytap account can modify WAN remote subnets using the following steps:

1. Access WAN management: Navigate to the WANs page by clicking Manage > WANs from the navigation bar and select the WAN you want to modify.
2. Disable the WAN: If the WAN is enabled, click Disable. This will stop all WAN traffic. 
3. Change remote subnets: Add or remove subnets on the right side of the page in the Remote Subnet section.
4. Disconnect and reconnect networks: On the WAN configuration page click the "Attached networks" tab. For each network click the disconnect button, wait a few seconds, then click the connect button. 
5. Test the WAN: Test the WAN to ensure it is functioning correctly with the new settings.
6. Enable the WAN: Click Enable to restart the flow of traffic through the WAN.